If you find any of these videos of value, you will want to purchase this textbook to gain that fundamental understanding all engineers need to excel as designers.

Visit Analog Devices LTSpice Tutorial playlist here - page 225.

In this video, I walk you through how to set up a simple RLC circuit in the free simulator, Circuit Lab, and run a simulation - page 225.

NE555 timer datasheet can be found here - page 227.

Sparkfun breadboard can be found here - page 243.

In this demo, I show an example of the switching noise occurring with long jumper wires when the return paths are worst-case and then optimized - page 251.

Assorted colored wires can be found here - page 260.

In this video, I show how easy it is to create short wires as needed to connect components in a solderless breadboard - page 263.

In this video, I walk you through how switching noise is created by mutual inductance between two loops - page 277.

Read this article on where return current flows - page 283.

In this video, I demonstrate the difference in switching noise between a separate, common return trace, and a return plane - page 287.

Use this calculator to calculate the loop inductance of a circular loop of wire - page 298.

Use this calculator to calculate the loop inductance of two round, parallel circular wires of some length - page 298 .

Use this calculator to calculate the loop inductance of two coplanar conductor strips - page 298 .